Menu
header photo

Auto Scanner Tool

Go2obd.net - Professional Auto Diagnostic Tools Supplier.

ECU turning tool-CARPROG

November 2, 2016

What are the sensors, actuators, and control mechanisms? How are they related?
Sensor intake temperature, intake air pressure sensor, solar term door position sensor, crankshaft position sensor, camshaft position sensor, temperature sensor, knock sensor, oxygen sensor. These sensors have independent functions, but they are closely matched, are indispensable. After the failure of a sensor, the engine may not be able to start, or cause the engine to work.
The executive body of the injector, duct, fuel pressure regulator, ignition wire, charcoal canister fuel pump, stepper motor etc..
Control mechanism: ECU.
The relationship between them: the sensor signal indicates the operating status of electrical parameters of the engine under various operating conditions, and passed to the ECU ECU, according to certain procedures, through calculation and comparison to determine the new signal, then ordered the execution. At the same time, ECU can store all the relevant parameters of the engine, but also can store the sensor fault code, although ECU can not express the failure of the actuator, but their drive part is able to express and can be stored.
CAR PROG Full is designed with regard to demands of our clients to have universal tool for odometers, dashboards, immobilizers repair, ECU repair and car radios, including advanced functions like EEPROM and microcontroller programmer, key ect.
Function:
1. Make the Universal tool - CAR PROG inside have powerful 16-bit MPU and full set of automotive interface drivers. In basic version you will get hardware with extra functions: 12 input/output pins forEEPROM in-circuit programmer, future possibility’s to make on the same hardware Microcontroller programmer, Immobiliser Transponder Key programmer with antenna adapter for 125/134 kHz, K-line diagnostic (dashboard odometer programming, immobilizer key programming), CAN line diagnostic,+5V/+12V output, USB, power supply only from USB.
2. Make the Low Cost tool - with CARPROG basic you will receive many extra functions (like car radio code calculator CC1, EEPROM programmer and VAG dashboard’s programmer by CAN) and all additional software’s you can buy extra according your need.
3. Make it User Friendly - Windows XP software, works without any installations, on all PC, use USB to PC link, all adapters schematics diagrams on-line.

You can go to OBDMORE.COM buy CARPROG.

Go Back

Comment